Browsing Mechanical & Manufacturing Eng (Scholarly Publications) by Title
Now showing items 444-463 of 677
-
Nanoengineering Approaches to Tune Thermal and Electrical Conductivity of a BiSbTe Thermoelectric Alloy
(2022)Nanoengineering of thermoelectric (TE) materials is an effective approach todecouple their electronic and thermal transport properties, hence enhancing their TE efficiency. Nanoengineering strategies can significantly ... -
Natural convection around a horizontal heated cylinder: The effects of vertical confinement
(2003)Natural convection heat transfer from a single horizontal cylinder and a pair of vertically aligned horizontal cylinders is investigated. Surface heat transfer distributions around the circumference of the cylinders are ... -
Natural convection from a triangular array of isothermal horizontal cylinders
(2021)Natural convection heat transfer from three isothermally heated horizontal cylinders submerged in water in a triangular arrangement is investigated. Two configurations, named here as one over two and two over one, are ... -
Natural convection from isothermal horizontal cylinders
(ASME, 2009)The research described here is concerned with natural convection from isothermal cylinders, with a particular focus on the interaction between a pair of vertically aligned cylinders. Prime attention was focused on how ... -
Natural Convection heat transfer and fluid dynamics for a pair of vertically aligned isothermal horizontal cylinders.
(2011)This paper discusses the close interaction between local fluid dynamics and natural convection heat transfer from a pair of isothermally heated horizontal cylinders submerged in water. The presence of a second heated ... -
A new Approach for experimental evaluation of contact stresses
(2005)n metal forming operations, t he intensity and distribution o f stresses at the tool/material interface have great influence on the pattern and mode of deformation. This is due to the effect ... -
New Insights into the Formation Mechanism of Intertwining Interfaces in Cold Spray
(ASM International, 2018)Experimental investigation supported by numerical modeling was conducted to explore the formation mechanism of intertwining interface in cold spray. The result revealed that low particle impact velocity and the consequent ... -
A new model for damping controlled fluidelastic instability in heat exchanger tube arrays
(2009)Heat exchnager tube arrays are susceptible to damage due to flow-induced vibration, with fluidelastic instability the potnetially the most destructive mechanism. In this paper a simple wake model consisting of a convecting ... -
NEXT GENERATION TACTILE SENSING FOR HUMAN-ROBOT INTERACTION IN INDUSTRIAL ROBOTICS
(2015)Tactile sensing is commonly viewed as one of the basic forms of sensing [24] – intelligent life is rarely found without some capacity for tactile sensing – and it is a fundamental sense in human perception [24, 29]; however ... -
Noise source identification for ducted fan systems
(American Institute of Aeronautics and Astronautics, 2008)Coherence based source analysis techniques can be used to identify the contribution of combustion noise in the exhaust of a jet engine and hence enable the design of noise reduction devices. However, when the combustion noise ... -
Noise Source Identification For Ducted Fan Systems (AIAA 2007-3693)
(2007)Understanding combustion noise source mechanisms, designing efficient acoustic liners and optimising active control algorithms for noise reduction requires the identification of the frequency and modal content of the ... -
Noise Source Location in Turbomachinery Using Coherence Based Modal Decomposition (AIAA 2009-3367)
(2009)Coherence based source analysis techniques can be used to identify the contribution of turbomachinery core noise sources to pressure measurements in the far-field. The usual approach is to locate a measurement sensor ... -
Non-collision injuries in urban buses: strategies for prevention
(2009)Public transport is a potentially important part of independent living for older people, but they are over-represented in non-collision bus injuries. This paper reports on a computational modelling approach to addressing ... -
Non-linear Identification Applied to Broadband Turbomachinery Noise
(2008)Coherence based source analysis techniques can be used to identify the contribution of broadband noise sources in the exhaust of a gas turbine and hence enable the design of noise reduction devices. However, when the ... -
Nonlinear Frequency Scattering of Broadband Noise in Turbomachinery (AIAA 2010-3805)
(2010)Coherence based source analysis techniques can be used to identify the contribution of broadband noise sources in the exhaust of a gas turbine and hence enable the design of noise reduction devices. However, when the ... -
Nonlinear vibro-acoustic behaviour in a circular membrane oscillator
(2009)Oscillating systems that produce noise at a frequency of excitation may have as an abatement solution the increase of the frequency of excitation to above the audible frequency limit, viz. 20kHz. This approach may not ... -
Notch and Mean Stress Effect in Fatigue as Phenomena of Elasto-Plastic Inherent Multiaxiality
(2011)The present paper summarises an attempt of estimating fatigue lifetime of notched metallic materials by directly accounting for the degree of multiaxiality of the local elasto-plastic stress/strain fields acting on the ... -
A novel antibacterial and biocompatible Ta-Ag coating fabricated by cold spray technology
(2023)Infection caused by bacterial contamination is a critical problem challenging the successful use of medical implants in orthopaedic and dental applications. Consequently, medical implants with antibacterial abilities ... -
A Novel Linear Air Amplifier Technology to Replace Rotary Fans in Data Center Server Rack Cooling
(2020)This paper investigates the potential of a novel linear airflow amplifier designed to replace rotary fans for various industries where their performance is undesirable like electronics cooling applications in compact data ...
