Electrospray array heat transfer
File Type:
PDFItem Type:
Journal ArticleDate:
2018Access:
openAccessCitation:
Gibbons, M.J. and Robinson, A.J., Electrospray array heat transfer, International Journal of Thermal Sciences, 2018, 129, 451-461Abstract:
Multiple source electrospraying enables higher droplet mass flux and greater cooling coverage area in comparison with its single source counterpart. The local convective heat flux to a multiple source electrospray array has been experimentally investigated using thin foil thermography. The designed array had a packing density of 115 Nn cm-2 and was operated in the cone-jet regime of spraying with ethanol as the working fluid. The electrospray array heat transfer performance is explored for varied flow rates (Q = 2–4 μL min-1 Nn-1 ) and electric fields (Ed = 4–8 kV cm-1 ). Cooling performance was shown to be dependent on both parameters. An 89% and 64% increase in the peak and average heat flux respectively was measured for the increasing electric field strength. This was due to increasing droplet mass flux, resulting in increasing contact line length density on the heated substrate, from narrowing of the spray plume, reduced residence time and droplet evaporation en-route to the target surface. This narrowing spray plume, at higher driving electric fields, also resulted in a more defined radial convective heat flux profile. The performance of the array was compared with that of a single source under similar experimental conditions. The array achieved more uniform cooling over a larger area than its single source counterpart. Comparing both devices for similar total working fluid flow rate highlight that the array delays the onset of pool cooling. This enables higher total working fluid flow rates in the evaporative cooling regime and subsequently higher convected thermal energy transport.
Author's Homepage:
http://people.tcd.ie/gibbonm3http://people.tcd.ie/arobins
Author: Robinson, Anthony; Gibbons, Michael
Type of material:
Journal ArticleSeries/Report no:
International Journal of Thermal Sciences;129;
Availability:
Full text availableKeywords:
Electrospray, Heat transfer, Electronic cooling, Spray cooling, Electric fieldDOI:
http://dx.doi.org/10.1016/j.ijthermalsci.2018.03.021Metadata
Show full item recordLicences: